#Specifically switch on or off the FTP engine's use of the EPSV command. By
#default, that one will always be attempted before the more traditional
#PASV command
#OPT_FTP_USE_EPSV (default number 1
OPT_FTP_USE_EPSV = 1
#Instruct libcurl to not use any signal/alarm handlers, even when using
#timeouts. This option is useful for multi-threaded applications.
#See libcurl-the-guide for more background information
#OPT_NOSIGNAL (default number 1
OPT_NOSIGNAL = 1
#set 1 to throw the header
#OPT_HEADER (default number 0
OPT_HEADER = 0
#Time-out connect operations after this amount of seconds, if connects
#are OK within this time, then fine... This only aborts the connect
#phase. [Only works on unix-style/SIGALRM operating systems]
#OPT_CONNECTTIMEOUT (default number 5
OPT_CONNECTTIMEOUT = 30
#Time-out the read operation after this amount of seconds
#OPT_TIMEOUT (default number 0
OPT_TIMEOUT = 300
#Set to explicitly forbid the upcoming transfer's connection to be re-used
#when done. Do not use this unless you're absolutely sure of this, as it
#makes the operation slower and is less friendly for the network.
#OPT_FORBID_REUSE (default number 0
OPT_FORBID_REUSE = 0